Esta web usa cookies para almacenar información en su ordenador. Usar la página web supone que acepta los términos de nuestra Política de Privacidad. Aurrera

ESKATU INFORMAZIOA

 
ARTIKULU ZIENTIFIKOAK

Gure artikulu zientifiko, tesiak, metodoak, memoriak eta zabalkunde teknologikoa.

EGILEAK:

Avoiding chatter in traverse cylindrical grinding by continuous workpiece speed variation

Regenerative chatter is one of the main limiting factors in traverse cylindrical grinding since it involves loss of productivity, geometric inaccuracies, superficial marks, and increase of roughness. Continuous workpiece speed variation is demonstrated to be an efficient method among chatter suppression techniques but variation parameters (amplitude and frequency) are normally selected based on trial-and-errors.

Therefore, a dynamic stability approach is proposed in which optimal combination of these parameters is defined based on semidiscretization technique, which consists of obtaining the eigenvalues of the transition matrix between consecutive workpiece rotations. Validation is carried out experimentally and good correlation between simulated and experimental results is achieved. Best combinations of variation parameters are achieved with amplitudes higher than 10% of the nominal workpiece speed and frequencies lower than 1 Hz. Then, the optimal parameters of continuous workpiece speed variation for chatter suppression can be predicted theoretically via semidiscretization. The application of this suppression technique has been successfully assessed for traverse cylindrical grinding.

ALDIZKARIA/HITZALDIA:

Journal of Manufacturing Science and Engineering-Transactions of the ASME

INFORMAZIO GEHIAGORENTZAT JAR ZAITEZ GUREKIN HARREMANETAN

(34)943 748 000

ARTIKULU ERLAZIONATUAK

Continuous workpiece variable speed: Model based practical application to avoid chatter in grinding
2010 KO URTARRILA

Simulation of an active vibration control system in a centerless grinding M. using a reduced Updated FE model (IDEKO,UPV)
2010 KO URTARRILA

Strategies for optimal use of fluids in grinding.
2011 KO URTARRILA

Effectiveness of continuous workpiece speed variatio chatter avoidance in throughfeed centerless grinding
2011 KO URTARRILA

Stability Analysis and Time Domain Simulation of Multiple Diameter Parts. During Infeed Centerless Grinding
2011 KO URTARRILA

Design of an active control of vibration in a centreless grinding machine: theoretical study and experimental implementation
2011 KO URTARRILA

Contact length estimation in grinding using thermocouple measurement and numerical simulation
2011 KO URTARRILA

Simulación y optimización de los recursos de Servicio de Asistencia Técnica (SAT)
2012 KO URTARRILA

Advances in centerless grinding technology
2012 KO URTARRILA

Model-based assistant tool for the settingup and optimization of centerless grinding process
2012 KO URTARRILA

Research advances and steps towards the control of geometric deviations in the surface grinding of big components
2013 KO URTARRILA

Semidiscretization for Stability Analysis of Infeed Cylindrical Grinding with Continuous Workpiece Speed Variation
2013 KO URTARRILA

Reduction Of Oil And Gas Consumption In Grinding Technology Using High Pour-Point Lubricants
2013 KO URTARRILA

Redesign of an active system of vibration control in a centerless grinding machine: numerical simulation and practical implementation
2013 KO URTARRILA

Continuous variable feed rate: a novel method for improving infeed grinding processes
2014 KO URTARRILA

Stability analysis and optimization algorithms for the set-up of infeed centerless grinding
2014 KO URTARRILA