This website uses its own and third-party cookies in order to improve the browsing experience. If you continue browsing you will be accepting expressly the use of these cookies. You can get more information on our Cookies Policy page.

Accept

APPLY FOR INFORMATIOIN

 
SCIENTIFIC ARTICLES

Our Scientific publications, thesis, methods for innovation, and divulgation articles.

AUTHORS:

Effect of the process variables on the mechanical and microstructural behaviour during cyclic deformation reversals

Effect of the process variables on the mechanical and microstructural behaviour during cyclic deformation reversals

The hot/warm levelling of the steel is applied at an intermediate temperature interval in which the deformation and phase transformation can interact. The main objective of this study was focused on analysing the behaviour of two steels in this temperature interval under different deformation conditions. To simulate the small plastic deformations of the industrial levelling process, low deformation multipass torsion tests with cyclic reversal were carried out. The thermo-mechanical cycles applied were designed with the intention of analysing the sensitivity during the cyclic deformation to: type of steel, initial state of the austenite, cooling speed and deformation temperature.

https://www.ceit.es/es/133-publicaciones-cientificas/4669-efecto-de-las-variables-de-proceso-en-el-comportamiento-mecanico-y-microestructural-durante-las-inversiones-ciclicas-de-la-deformacion

MAGAZINE/CONFERENCE:

Tecnun 50th Anniversary Conference. San Sebastián

CONTACT WITH US FOR MORE INFORMATION

(34)943 748 000

RELATED ARTICLES

THERE ARE NO RELATED ARTICLES