Esta web usa cookies para almacenar información en su ordenador. Usar la página web supone que acepta los términos de nuestra Política de Privacidad. Aurrera

ESKATU INFORMAZIOA

 
ARTIKULU ZIENTIFIKOAK

Gure artikulu zientifiko, tesiak, metodoak, memoriak eta zabalkunde teknologikoa.

EGILEAK:

Analysis of Directional Factors in Milling: Importance of Multifrequency Calculation and of the Inclusion of the Effect of the Helix Angle

The concept of directional factor for chatter stability analysis has been used from a long time ago. The analysis of its evolution for different feed directions in milling processes provides a good way of selecting the best cutting conditions. For very stable cutting directions, corresponding to very low directional factors, the single frequency analysis gives unacceptable results and multifrequency, or alternative solutions as semi-discretisation must be used.

It is found also that the period doubling lobes extend at both sides of the tooth pass frequency equivalent to twice the natural frequency. In these cases, helix angle has a very important effect on the stability. For end milling processes, where the mill axial pitch can be of the order of the stable limit depth of cut, a very stable situation is found except in those areas corresponding to period doubling, where instability islands are found. Besides, a graphical construction for accurate estimation of the stable limit depth of cut and starting rotational speed of the period doubling lobes is proposed.

ALDIZKARIA/HITZALDIA:

International Journal of Advanced Manufacturing Technology

INFORMAZIO GEHIAGORENTZAT JAR ZAITEZ GUREKIN HARREMANETAN

(34)943 748 000

ARTIKULU ERLAZIONATUAK

An automatic spindle speed selection strategy to obtain a stability of high speed milling
2010 KO URTARRILA

Application of continuous spindle speed variation for chatter avoidance in roughing milling.
2011 KO URTARRILA

Prediction of multiple dominant chatter frequencies in millingprocesses
2011 KO URTARRILA

Identification of cutting force characteristics based on chatter experiments
2011 KO URTARRILA

Chatter suppression in a high speed magnetic spindle by adding damping
2014 KO URTARRILA

Ball bearings damage detection using traditional signal processing algorithms
2013 KO URTARRILA

INTERACTION BETWEEN MULTIPLE MODES IN MILLING PROCESSES
2013 KO URTARRILA

An Integrated System for Machine Tool Spindle Head Ball Bearing Fault Detection and Diagnosis
2013 KO URTARRILA

Effect of Mode interaction on stability of milling processes
2013 KO URTARRILA

Optimisation of face milling operations with structural chatter using a stability model based process planning methodology
2014 KO URTARRILA

Receptance coupling for tool point dynamic prediction by fixed boundaries approach
2014 KO URTARRILA

Cylindrical milling tools: Comparative real case study for process stability
2014 KO URTARRILA

Stability analysis of milling with irregular pitch tools by the implicit subspace iteration method
2014 KO URTARRILA

Coupled model for simulating active inertial actuators in milling processes
2015 KO URTARRILA

Implicit subspace iteration as an efficient method to compute milling stability lobe diagrams
2015 KO URTARRILA

Active suppression of structural chatter vibrations using machine drives and accelerometers

Hardware-in-the-loop simulator for stability study in orthogonal cutting
2015 KO URTARRILA

Chatter suppression in ram type travelling column millling machines using a biaxial inertial actuator
2013 KO URTARRILA