Esta web utiliza cookies para optimizar la navegación. Al continuar con su visita, usted acepta el uso de cookies y nuestra política de privacidad. Acepto

SOLICITA INFORMACIÓN

 
ARTÍCULOS DE DIVULGACIÓN

Nuestras Publicaciones de artículos científicos y de difusión tecnológica así como tesis, métodos, y memorias.

Cylindrical milling tools: Comparative real case study for process stability

Critical comparison is presented related to the stability behaviour of milling processes performed by conventional, variable helix and serrated milling tools. The paper presents a general milling model linked to any non-proportionally damped dynamic system. Extended multi frequency solution and semidiscretization are implemented and used to calculate the stability of stationary milling. Measurements performed in industrial environment validate the general numerical algorithm that is able to predict the stability conditions of milling processes carried out by cylindrical cutters of optional geometry. Both the calculations and the measurements confirm that, for roughing operations, the highest stability gain can be achieved by serrated cutters. It is also demonstrated that variable helix milling tools can achieve better stability behaviour only if their geometry is optimized for the given cutting operation.

Enero 2014

CONTACTA CON NOSOTROS PARA MÁS INFORMACIÓN

(34)943 748 000

ARTÍCULOS RELACIONADOS

Comparative analysis of spindle speed variation techniques in milling
MAYO DE 2004

Optimization of hard material roughing by jeans of a stability model
ABRIL DE 2005

Time and frequency domain models for chatter prediction in milling
NOVIEMBRE DE 2005

Evaluation Study on Detection Techniques for Bearing Incipient Faults
ENERO DE 2005

Feasibility study on diagnostic methods for detection of bearing faults at an early stage
JULIO DE 2005

Stability study of the milling process using an exponential force model in frequency domain
MARZO DE 2006

Chatter avoidance method for milling process based on sinusoidal spindle speed variation method: simulation and experimental results
SEPTIEMBRE DE 2007

Analysis of Stability of Structural Modes in Milling Processes
ABRIL DE 2010

Stability of serrated milling cutters
JUNIO DE 2010

Effect of mode interaction on stability of milling processes
MAYO DE 2010

Aumento de la disponibilidad de máquina
ENERO DE 2010

Fixed Boundaries Receptance Coupling Substructure Analysis for Tool Point Dynamics Prediction.
OCTUBRE DE 2011

General Milling Stability Model for Cylindrical Tools
JULIO DE 2012

Self-tuning semi-active tuned-mass damper for machine tool chatter suppression
MARZO DE 2012

Ball bearing damage detection using traditional signal processing algorithms
ABRIL DE 2013

Design of a bench hardware-in-the-loop system for the study of chatter in turning.
MAYO DE 2013

Diseño de un amortiguador activo para la eliminación de chatter en máquina herramienta
NOVIEMBRE DE 2013

Mechatronic Spindle Head for Chatter Suppression in Heavy Duty Operations
JULIO DE 2014

Chatter suppression in a high speed magnetic spindle by adding damping
FEBRERO DE 2014

Optimal control laws for chatter suppression using inertial actuator in milling processes
NOVIEMBRE DE 2014

Real milling force based dynamic parameter extraction method
DICIEMBRE DE 2014

Limiting factors for the active suppression of structural chatter vibrations using machine’s drives
JULIO DE 2015