Esta web usa cookies para almacenar información en su ordenador. Usar la página web supone que acepta los términos de nuestra Política de Privacidad. Aurrera

ESKATU INFORMAZIOA

 
DIBULGAZIO ARTIKULUAK

Gure artikulu zientifiko, tesiak, metodoak, memoriak eta zabalkunde teknologikoa.

Cylindrical milling tools: Comparative real case study for process stability

Critical comparison is presented related to the stability behaviour of milling processes performed by conventional, variable helix and serrated milling tools. The paper presents a general milling model linked to any non-proportionally damped dynamic system. Extended multi frequency solution and semidiscretization are implemented and used to calculate the stability of stationary milling. Measurements performed in industrial environment validate the general numerical algorithm that is able to predict the stability conditions of milling processes carried out by cylindrical cutters of optional geometry. Both the calculations and the measurements confirm that, for roughing operations, the highest stability gain can be achieved by serrated cutters. It is also demonstrated that variable helix milling tools can achieve better stability behaviour only if their geometry is optimized for the given cutting operation.

Urtarrila 2014

INFORMAZIO GEHIAGORENTZAT JAR ZAITEZ GUREKIN HARREMANETAN

(34)943 748 000

ARTIKULU ERLAZIONATUAK

Comparative analysis of spindle speed variation techniques in milling
2004 KO MAIATZA

Optimization of hard material roughing by jeans of a stability model
2005 KO APIRILA

Time and frequency domain models for chatter prediction in milling
2005 KO AZAROA

Evaluation Study on Detection Techniques for Bearing Incipient Faults
2005 KO URTARRILA

Feasibility study on diagnostic methods for detection of bearing faults at an early stage
2005 KO UZTAILA

Stability study of the milling process using an exponential force model in frequency domain
2006 KO MARTXOA

Chatter avoidance method for milling process based on sinusoidal spindle speed variation method: simulation and experimental results
2007 KO IRAILA

Analysis of Stability of Structural Modes in Milling Processes
2010 KO APIRILA

Stability of serrated milling cutters
2010 KO EKAINA

Effect of mode interaction on stability of milling processes
2010 KO MAIATZA

Aumento de la disponibilidad de máquina
2010 KO URTARRILA

Fixed Boundaries Receptance Coupling Substructure Analysis for Tool Point Dynamics Prediction.
2011 KO URRIA

General Milling Stability Model for Cylindrical Tools
2012 KO UZTAILA

Self-tuning semi-active tuned-mass damper for machine tool chatter suppression
2012 KO MARTXOA

Ball bearing damage detection using traditional signal processing algorithms
2013 KO APIRILA

Design of a bench hardware-in-the-loop system for the study of chatter in turning.
2013 KO MAIATZA

Diseño de un amortiguador activo para la eliminación de chatter en máquina herramienta
2013 KO AZAROA

Mechatronic Spindle Head for Chatter Suppression in Heavy Duty Operations
2014 KO UZTAILA

Chatter suppression in a high speed magnetic spindle by adding damping
2014 KO OTSAILA

Optimal control laws for chatter suppression using inertial actuator in milling processes
2014 KO AZAROA

Real milling force based dynamic parameter extraction method
2014 KO ABENDUA

Limiting factors for the active suppression of structural chatter vibrations using machine’s drives
2015 KO UZTAILA