Esta web utiliza cookies para optimizar la navegación. Al continuar con su visita, usted acepta el uso de cookies y nuestra política de privacidad. Acepto

SOLICITA INFORMACIÓN

 
ARTÍCULOS DE DIVULGACIÓN

Nuestras Publicaciones de artículos científicos y de difusión tecnológica así como tesis, métodos, y memorias.

Chatter suppression in a high speed magnetic spindle by adding damping

Magnetic bearings are used in several applications, but they didn’t succeed in the machine tool industry, due basically to their low damping, with its associated low chatter free cutting capacity. This work shows the development of a high speed milling spindle supported on magnetic bearings with high chatter resistance. That is achieved by using control strategies which add damping to the bearings. Excitation by means of the magnetic bearings is used to identify its dynamic behaviour and to optimize the damping parameters. Finally the results of the industrial validation are presented; showing an increase of six times in the cutting capacity.

Febrero 2014

CONTACTA CON NOSOTROS PARA MÁS INFORMACIÓN

(34)943 748 000

ARTÍCULOS RELACIONADOS

Comparative analysis of spindle speed variation techniques in milling
MAYO DE 2004

Optimization of hard material roughing by jeans of a stability model
ABRIL DE 2005

Time and frequency domain models for chatter prediction in milling
NOVIEMBRE DE 2005

Evaluation Study on Detection Techniques for Bearing Incipient Faults
ENERO DE 2005

Feasibility study on diagnostic methods for detection of bearing faults at an early stage
JULIO DE 2005

Stability study of the milling process using an exponential force model in frequency domain
MARZO DE 2006

Chatter avoidance method for milling process based on sinusoidal spindle speed variation method: simulation and experimental results
SEPTIEMBRE DE 2007

Analysis of Stability of Structural Modes in Milling Processes
ABRIL DE 2010

Stability of serrated milling cutters
JUNIO DE 2010

Effect of mode interaction on stability of milling processes
MAYO DE 2010

Aumento de la disponibilidad de máquina
ENERO DE 2010

Fixed Boundaries Receptance Coupling Substructure Analysis for Tool Point Dynamics Prediction.
OCTUBRE DE 2011

General Milling Stability Model for Cylindrical Tools
JULIO DE 2012

Self-tuning semi-active tuned-mass damper for machine tool chatter suppression
MARZO DE 2012

Ball bearing damage detection using traditional signal processing algorithms
ABRIL DE 2013

Design of a bench hardware-in-the-loop system for the study of chatter in turning.
MAYO DE 2013

Diseño de un amortiguador activo para la eliminación de chatter en máquina herramienta
NOVIEMBRE DE 2013

Cylindrical milling tools: Comparative real case study for process stability
ENERO DE 2014

Mechatronic Spindle Head for Chatter Suppression in Heavy Duty Operations
JULIO DE 2014

Optimal control laws for chatter suppression using inertial actuator in milling processes
NOVIEMBRE DE 2014

Real milling force based dynamic parameter extraction method
DICIEMBRE DE 2014

Limiting factors for the active suppression of structural chatter vibrations using machine’s drives
JULIO DE 2015